Saturday, October 16, 2010
Stockmar Block Crayon Roll
I just finished this crayon roll for Yoav's birthday. It can hold 12 Stockmar block crayons. Disregard the water marks - I used a water erasable pen for markings...
Outside fabric, inside fabric and interfacing fabric: 6.5" x 11.25"
Red fabric (two pieces): 4" x 11.25" (folded in half lengthwise before sewing to the inside fabric)
Ribbon: 20" (this time I used ribbon from Lillalotta).
1. Cut all fabrics
2. Iron interfacing to wrong side of inside fabric
3. Fold crayon-holding fabric (my red fabric) in half lengthwise and iron. Pin in place (fold is toward the inside of the crayon roll). Make a vertical mark at 2.125" from the left edge, then four more markings every 1.75".
4. Stitch along markings, going back and forth a bit at beginning and end.
5. Fold ribbon in half with pattern on the INSIDE and topstitch to right side of inside fabric.
6. Pin ribbon to the inside fabric so you don't accidentally sew over it.
7. Place right side of outer fabric to right side of inner fabric and sew with 1/4" seam allowance, leaving a 3.5" hole for turning right side out (I left hole at short end on the side without the ribbon).
8. Trim corners and turn right side out.
9. Poke out corners with a knitting needle or similar, iron and topstitch 1/8" all around.
10. Insert crayons and enjoy!